Mixing:

Mix two parts of A and one part of B together at low speed
in a separate container for a minimum of three
minutes, until a completely homogeneous mixture is obtained. Make sure to scrap sides and bottom
of mixing container so no unmixed material remains. 

Once the product is properly mixed, it needs
to be immediately poured on the floor. Leaving mixed material
for too long in a mixing pail will create an exothermic reaction and
the product will no longer be usable.

Application:

Apply with a squeegee in a thin coat
without back rolling to seal the surface properly. This will also
help reduce the creation of pin holes. 

If there is appearance of pinholes during the application, allow sufficient time to go back and
either burst the pin holes by rolling back and forth or with another
squeegee pass. If there are still pinholes after applying the first
coat, sand and plug the pinholes with epoxy gel prior applying
the second coat. A thickness of 4-6 mils is recommended for the
EPOXY PRIMER

Lab Surface Epoxy Primer

Product Overview

Lab Surface Epoxy Primer is a two component 100% solids epoxy primer with no VOC. Formulated with cycloaliphatic amine technology, it delivers superior adhesion, low viscosity, long working time, and early blush resistance for high traffic concrete surfaces.

Key Features

• 100% solids formula with no VOC for an environment friendly primer
• Minimal odor for a safer work environment
• Excellent penetration and adhesion on concrete
• Low viscosity for easy application
• High elongation to absorb impact and accommodate slab movement
• Resists amine blush and contamination for a smooth finish
• Long working time for large area coverage
• Fast curing to speed up project timelines

Recommended Uses

• Manufacturing facilities and warehouses
• Commercial centers and retail stores
• Office buildings and public facilities
• Garages
• Food and beverage processing and preparation plants
• Hospitals, schools, and pharmaceutical sites
• Other high traffic industrial and commercial floors

Application Notes

• Ensure concrete is clean, dry, and free of grease or contaminants
• Mix components A and B at a 2 to 1 ratio by volume
• Apply with a roller or squeegee at the recommended coverage rate
• Maintain ambient temperature between 50 °F and 90 °F during application
• Allow primer to fully cure before applying subsequent coats